-
- Генераторы: mощность 500 Вт, частота 150-400 кГц
- Генераторы: мощность 1,2 - 2,4 кВт, частота 150 - 400 кГц
- Генераторы: mощность 4,2 - 10 кВт, частота 150 - 400 кГц
- Генераторы: mощность 10-15 кВт, частота 50-150 кГц
- Генераторы: mощность 30-45 кВт, частота 50-150 кГц
- Генераторы: mощность 65-135 кВт, частота 50-150 кГц
- Генераторы: mощность 180-270 кВт, частота 50-150 кГц
- Генераторы: mощность 20-35-50 кВт, частота 15-45 кГц
- Генераторы: mощность 75-150 кВт, частота 15-45 кГц
- Генераторы: mощность 200-500 кВт, частота 15-45 кГц
- Генераторы: mощность 20-50 кВт, частота 5-15 кГц
- Генераторы: mощность 75-200 кВт, частота 5-15 кГц
- Генераторы: mощность 250-500 кВт, частота 5-15 кГц
- Генераторы: mощность 75-250 кВт, частота 2-6 кГц
- Генераторы: mощность 300-500 кВт, частота 2-6 кГц
-
- Генераторы серии CX, частота: 50-120 кГц, мощность: 5-25 кВт
- Генераторы серии SWS, частота: 15-30 кГц, мощность: 25-260 кВт
- Генераторы (печи) для штамповки и ковки серии MFS, частота: 0,5-10кГц, мощность: 80-500кВт.
- Плавильные печи MFS, частота: 0,5-10 кГц, мощность: 70-200 кВт
- Генераторы серии UHT, частота: 200-400кГц, мощность: 10-160кВт
What is the purpose of induction heating generators?
Induction generators convert alternating current to a higher frequency current to then deliver it to the operating coil, allowing an electromagnetic field to be created within it.
When a workpiece is placed in this field, eddy currents are induced in the workpiece. The friction caused by these currents generates precise, clean, non-contact heat. Depending on the power and on the frequency, we are able to determine the heating rate and the penetration depth of the heat.
A water cooling system is usually required to cool the work coil and induction system.
Operating frequency
The size of the workpiece and the heating application dictate the operating frequency of the induction heating equipment. In general, the larger the workpiece, the lower the frequency and the smaller the workpiece, the higher the frequency.
The operating frequency is determined by the tank circuit capacitance, coil inductance and workpiece material properties.
Power requirements
The power required to heat the workpiece depends on:
- The mass of your work piece;
- The material properties of your work piece;
- The temperature increase you require;
- The heating time required to meet your process needs;
- The effectiveness of the field owing to the coil design;
- Any heat losses during the heating process.
Once the power required to heat the workpiece is determined, the appropriate induction heating equipment can be selected, taking into account the coupling efficiency of the coil.