Šviesolaidinio kabelio hermetiškas sandarinimas covar jungtyje
  • Šviesolaidinio kabelio hermetiškas sandarinimas covar jungtyje

Nuotraukos yra skirtos tik informaciniams tikslams. Peržiūrėkite produkto specifikaciją

please use latin characters

Gamintojas: Ambrell

Šviesolaidinio kabelio hermetiškas sandarinimas covar jungtyje

Hermetically sealing a fiber optic cable in a kovar ferrule


Objective: Soldering a fiber optics cable in a ferrule to form a hermetic seal.


Frequency: 346 kHz


Equipment:
  • Ambrell 1.2 kW induction heating system, equipped with a remote workhead containing one 0.66μF capacitor;
  • An induction heating coil designed and developed specifically for this application.

Material: Panda PM fiber 0.0098” (.25mm) dia, kovar ferrule 0.086” (2.2mm) dia and metal enclosure 1.96” x 1.06” x 0.23” thick (50mm x 27mm x 5.9mm thick), solder preforms and flux


Temperature: 450 ºF (232 ºC)


Process:

A single turn channel “C” coil is used for this soldering application. Assembly is fluxed at the joint area and power is applied for 15 seconds to create the hermetic seal in the ferrule. The customer chose our solution due to the ability to design the single channel “C” coil. The coil heats quickly so that the heat does not travel to heat sensitive components in the case.


Benefits:
  • Instant start up time requiring very little power resources;
  • Targets small areas with pin point accuracy;
  • Clean source of heat;
  • Easily integrated into existing automated systems;
  • Even distribution of heating.
mažiau
Skaityk daugiau

Atsiųskite užklausą

Ar Jūs domina šis produktas? Ar Jums reikia papildomos informacijos ar individualaus pasiūlymo?

Susisiekite su mumis

KLAUSKITE PRODUKTO close
Pranešimas sėkmingai išsiųstas.
KLAUSKITE PRODUKTO close
Naršyti

Pridėti į norų sąrašą

tu turi būti prisijungęs

Hermetically sealing a fiber optic cable in a kovar ferrule


Objective: Soldering a fiber optics cable in a ferrule to form a hermetic seal.


Frequency: 346 kHz


Equipment:
  • Ambrell 1.2 kW induction heating system, equipped with a remote workhead containing one 0.66μF capacitor;
  • An induction heating coil designed and developed specifically for this application.

Material: Panda PM fiber 0.0098” (.25mm) dia, kovar ferrule 0.086” (2.2mm) dia and metal enclosure 1.96” x 1.06” x 0.23” thick (50mm x 27mm x 5.9mm thick), solder preforms and flux


Temperature: 450 ºF (232 ºC)


Process:

A single turn channel “C” coil is used for this soldering application. Assembly is fluxed at the joint area and power is applied for 15 seconds to create the hermetic seal in the ferrule. The customer chose our solution due to the ability to design the single channel “C” coil. The coil heats quickly so that the heat does not travel to heat sensitive components in the case.


Benefits:
  • Instant start up time requiring very little power resources;
  • Targets small areas with pin point accuracy;
  • Clean source of heat;
  • Easily integrated into existing automated systems;
  • Even distribution of heating.
mažiau
Skaityk daugiau