Glühen der Verlängerung der Hydraulikmotorwelle vor der Bearbeitung
Glühen der Verlängerung der Hydraulikmotorwelle vor der Bearbeitung

Fotos dienen nur zu Informationszwecken.

please use latin characters

Hersteller: Ambrell

Glühen der Verlängerung der Hydraulikmotorwelle vor der Bearbeitung

Annealing the end of a hydraulic motor shaft prior to machining


Objective: Annealing the end of a steel hydraulic motor shaft prior to machining.


Frequency: 259 kHz


Equipment:
  • Ambrell 4.2 kW induction heating system, equipped with a remote workhead containing one 1.0 μF capacitor;
  • A coil specifically designed for this application.

Material: 0.75” (19mm) diameter steel rod, 6” (152.4mm) long with a keyway at the end.


Temperature: 1350 °F (732 °C)


Process:

A three turn helical coil is used for annealing the motor shaft. The end of the motor shaft is placed in the coil and power is applied for 20 seconds to reach 1350 ºF (732 ºC) and turn the steel red hot.


Benefits:
  • High efficiency, low energy cost;
  • Precise and controllable placement of heat to anneal only the required area;
  • Faster production process;
  • Consistent results.
Weniger
Weiterlesen

Senden Sie eine Anfrage

Interessieren Sie sich für dieses Produkt? Benötigen Sie zusätzliche Informationen oder individuelle Preise?

Kontaktiere uns
FRAGEN SIE NACH DEM PRODUKT close
Vielen Dank für die Zusendung Ihrer Nachricht. Wir werden so schnell wie möglich antworten.
FRAGEN SIE NACH DEM PRODUKT close
Durchsuche
Senden Sie eine Anfrage

Zur Wunschliste hinzufügen

Sie müssen eingeloggt sein

Annealing the end of a hydraulic motor shaft prior to machining


Objective: Annealing the end of a steel hydraulic motor shaft prior to machining.


Frequency: 259 kHz


Equipment:
  • Ambrell 4.2 kW induction heating system, equipped with a remote workhead containing one 1.0 μF capacitor;
  • A coil specifically designed for this application.

Material: 0.75” (19mm) diameter steel rod, 6” (152.4mm) long with a keyway at the end.


Temperature: 1350 °F (732 °C)


Process:

A three turn helical coil is used for annealing the motor shaft. The end of the motor shaft is placed in the coil and power is applied for 20 seconds to reach 1350 ºF (732 ºC) and turn the steel red hot.


Benefits:
  • High efficiency, low energy cost;
  • Precise and controllable placement of heat to anneal only the required area;
  • Faster production process;
  • Consistent results.
Weniger
Weiterlesen
Kommentare (0)